FLOOR DOCTOR HARD FLOOR CLEANER
1. Remove the cardboard nozzle protector. 2. Firmly insert the handle into the unit base until you hear the handle click into place. If you do not hear the handle click into place, gently apply pressure until the handle clicks into place. 3. To remove handle from the unit, first remove the screw. Once the screw has been removed, utilize a tool to press the spring located to release the handle. Once handle is successfully released remove the handle from unit base.
CLEAN WATER TANK INSTRUCTIONS
1. To fill the clean water tank, gently press Tank Release Button on the clean water tank to release tank from the unit. 2. Remove tank from the unit and fill with hot tap water, leaving enough room to add 1 tablespoon of FloorDoctor hard floor cleaning solution as instructed on the solution bottle. 3. Once the water and solution have been added and place the tank back on the unit pressing gently until you hear the tank click into place. Press Power Switch to start the machine 1. Press once for standard cleaning mode – Low Speed will have a blue light. 2. Press twice for boost mode for heavy dirt – High Speed with be a blue flashing light 3. Press third time to turn off the machine. NOTE: Press the Solution Trigger when moving forward to release cleaning solution.
CLEANING DIRTY WATER TANK
Please always switch off the machine when it stands up. If not, the machine may lose suction due to the valve being activated accidentally. 1. Lift red release button to remove dirty water tank. 2. Remove the dirty water tank from the machine. 3. Release the lock buttons on the sides of the dirty water tank and remove the lid. 4. Empty and clean the dirty water tank. 5. Rinse with fresh hot tap water. 6. Thoroughly dry the dirty water tank and place the tank back in the unit securely locking the tank in place.
CLEANING NOZZLE/BRUSH ROLL
1. Remove the nozzle and brush roll cover and rinse with warm tap water. 2. Take out the brush roll. 3. Rinse the brush roll with warm tap water and mild soap. Dry and replace in unit. 4. To replace cover, press the Hook A into the Lock Hole A, then press Hook B into Lock Hole B. 5. Press the cover into place to close it.
CHARGING THE BATTERY
The indicator light will flash red when it’s power is low. Please charge it. 1. Before charging the unit, please ensure that all water has been removed from the clean and dirty water tanks and the machine is dry. 2. To charge the machine, connect the external charger cord to the unit and plug into the wall outlet
MACHINE/BATTERY USE, STORAGE AND CHARGING
• Battery takes 6 hours for initial charge and 3.5 hours for normal recharge. The indicator light on the front of the machine will turn blue when the machine is fully charged. • Battery run time is approximately 30 minutes. • Recommended ambient temperature range 32 ºF to 110 ºF.