FLEXCLEAN SUPPORT

USING THE MACHINE

To start using your FlexClean, ensure there is clean water in your tank filled to the specified amount and set in place. The machine should be plugged in and placed in the area to be cleaned.

CLEANING YOUR CARPET

Turn on the Flow Control Dial to the Carpet Deep Clean or Carpet Quick Dry setting based on desired cleaning. Push the Power Switch to “Floor Cleaning” position. Step on the Handle Release Pedal to pull back/release the Main Handle.

Press the Soap & Scrub Trigger to apply cleaning solution to the carpet. Make 2 slow wet passes over same area with trigger squeezed. (1 forward,1 back). For heavily soiled areas, make up to 4 wet passes. To speed drying process, make 2 dry passes by releasing the soap & scrub trigger – this will only engage the suction. Leave the machine on for 15 seconds after cleaning to allow for all of the dirty solution to be collected into the Dirty Water Tank.

CLEANING YOUR HARD FLOORS

Once the machine is ready to placed in the hard floor area to be cleaned, turn the Flow Control Dial to the Hard Floor setting. Push the Power Switch to “Floor Cleaning” position. Step on the Handle Release Pedal to pull back/release the Main Handle.

Press the Soap & Scrub Trigger to apply cleaning solution to the floor. Make 2 slow wet passes  (1 forward, 1 back) over same area. To remove any extra moisture from the floor, Release Soap & Scrub Trigger and make 2 dry passes. Leave the machine on for 15 seconds after cleaning to allow for all of the dirty solution to be collected into the Dirty Water Tank.

CLEANING WITH THE UPHOLSTERY TOOL

To prepare the FlexClean to be used with the upholstery tool, squeeze and lift the floor nozzle to remove from the machine.

Insert the Upholstery Tool Connector in the Upholstery Tool Port, located behind the Nozzle. Turn the Flow Control Dial to the Deep Clean or Quick-Dry setting based on desired cleaning.

Push the Power Switch to the “Upholstery Clean” position. Position the Upholstery Tool in front of the area or stain you want to deep clean. Squeeze the Spray Trigger on the Upholstery Tool to apply cleaning solution to the area. Move the tool back and forth to spray, scrub and extract stains and soil. Make sure to press the front of the tool down into the surface to remove dirty water. Tip: release the spray trigger as you near the edge of the cleaning area to avoid overspraying.

Leave the machine on for 15 seconds after cleaning to allow for all of the dirty solution to go through entire hose and be collected into the Dirty Water Tank.